Swimline 5100 Page 1 Bedienungsanleitung PDF herunterladen

You will use a series of pre-drilled holes, spaced approximately 1-1/2" and 7-1/2" inches from each end,

to join the large tubing to the small tubing. These holes are space 120 degrees apart. At the appropriate

time you will secure with self-drilling and tapping SS screws. Also take note of large holes that pierce

both end tubes. You will eventually use these holes to anchor tubing to Crank Handles with bolts provided.

• Loosely assemble extruded tubes together. Slide excess width into adjoining tubes, dividing it up

as equally as possible. Note: You must have a minimum of 9” of overlap in each tube!

• Measure the width across the pool from plug surface to plug surface.

• Adjust the total length of the tube assembly to fit the span.

• Lock the tubes together by rotating each adjoining tube in the opposite direction. (See illustrations)

• Secure each tube with just 1 self drilling screw in each adjoining tube.

• Attach the tube assembly into the Crank and Tubing Plugs and check for fit.

• When all is OK drill and screw the remaining screws at each end of the overlapped poles. You should

have 6 screws on each tube end where there is a connection.

• Assemble Tube assembly together with Crank Handles and Tube Plugs by lining up hole in the end of

each tube fitted into Crank Handle and secure with plastic bolt and nut provided.

9. Attach Straps to Tubes:

Come in 6 inches from each tube end and attach a strap plate to the aluminum tube assembly.

Use the self drilling screws on the drill line to attach the plate. Look at the holes that were pre-drilled

at the factory and use the same drill line. There are 6 lines on each tube.

Take the remaining strap plates and connect them evenly along the length of the tube assembly.

Attach Straps to strap plate. (See illustration Above Right)

10. Attach Solar Blanket to Straps:

If Wheel is to be placed at the end of the pool, attach cover to strap plate with

plastic screw as shown in Illustration Below Left. If Wheel is to be placed in

offset position, then attach cover to strap plate forming a fold to act like a

hinge and the plastic screw will go through two layers of the solar blanket

as shown in Illustration Below Right. Bubbles should face down.

Advanced Reel System

For In Ground Solar Pool Covers

Minimum

Overlap

Use Large Plug

For Pole Kit 5116

Only!

Measure Plug Surface To Plug Surface

Twist

Tubing To

Remove

Excess

Play Prior To

Screwing Together.

Thread

Strap

as Shown

Solar Blanket

Strap & Bracket

Plastic Screw

Solar Blanket Folded

Plastic Screw

Strap & Bracket

Advanced Reel System 1

Inhaltsverzeichnis

Seite 1 - Advanced Reel System

You will use a series of pre-drilled holes, spaced approximately 1-1/2" and 7-1/2" inches from each end, to join the large tubing to the

Kommentare zu diesen Handbüchern

Keine Kommentare

Swimline 5100 Page 1 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Zubehör fürs Wasser Swimline 5100 Page 1 herunter. Swimline 5100 Page 1 User Manual [en] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Zubehör fürs Wasser Swimline 5100 Page 1